RESANTA LUX ASN-10000N / 1-Ts

Advantages: Price, appearance, fulfills its functions completely.

Disadvantages: Has not revealed yet

Comment:

Advantages: I don't know how, but when in our gardening the electrician applied 2 phases to all the sockets, the stabilizer turned off the machines and nothing burned out for me, refrigerators and other household appliances burned out in 90% of them.

Disadvantages: Didn't notice yet

Comment: Energy-saving light bulbs do not burn out during the use of the stabilizer. pah-pah-pah, Previously, it was not enough for 6 months. I do not know the merit of the stabilizer or the coincidence of circumstances, but I tend to the first.

Advantages: It sharply stabilizes during sudden surges in the network and when operating from an electric generator. I like that you can neatly hang it on the wall.

Disadvantages: The new one has no connection pads. The percentage of accuracy of 8% is not enough, but sufficient for household appliances.

Comment: I put 3 pieces for each phase in the house, 5-6 years ago. Electricity consumption, even heating (Irkutsk), so they work at full capacity in winter, and less in summer, but I also warm up the outdoor pool. Jumping voltage instantly stabilizes. One broke, but through my fault, the overloaded stood for a long time (a year) (Overloaded, it is loaded constantly close to 90% of the capacity). Repairs approximately 5% of the cost. Better to count your consumption. Another of the stabilizers (of the same three) I use when emergency powering the house from a power plant. It will not be superfluous. The station often chokes from a sharp load or when gasoline runs out and therefore sharp surges in electricity. And the stabilizer helps a lot. I advise 100% One broke, but through my fault, I stood overloaded for a long time (a year) and did not tighten contacts after a long work. Repairs cost about 5% of the cost. If, after three years of operation, I tightened the contacts, it most likely would not have broken.You need to stretch the pads at the entrance to the stub even before work, rather weak. Well, these are not even disadvantages, but a warning for the user. When switching (Stabilization), incandescent lamps slightly change the incandescence (slightly noticeable). Because the% accuracy is not high 8%, but this is normal for household appliances. If the voltage is constant without sudden surges, then it is normal. If it jumps strongly, then the stabilizer will constantly click, so you need to put it away from the bedroom. Loudly audible at night.

Advantages: beautiful appearance, digital display, can be hung on the wall, not high price in comparison with other manufacturers presented in the store

Disadvantages: heavy weight, you have to use reinforced anchors

Comment: A month ago I purchased this stabilizer. After purchase, I called an electrician for installation. The electrician hung this stabilizer near the meter. After switching on, the display showed an input voltage of 160V. The output was 220V. Visually noticed that the bulbs were already burning brighter. The wife noticed that the microwave also began to warm up as before, and not for half an hour. I advise everyone who has problems with electricity.

Advantages: Shows input and output voltages, works in high humidity.

Disadvantages: no

Comment: They had problems with electricity, the voltage dropped. We bought a voltage stabilizer and fixed it on the wall. Now we are satisfied! We calmly watch TV in the evening, when the use of electrical appliances is at its peak.

Advantages: Carries out its functions without attracting too much attention. The electric boiler of the heating system began to heat the coolant to the required level many times faster. The diode lamps stopped blinking, as it was during a voltage drop. The microwave oven heats up in 1 minute as it warmed up in 3. In general, we felt all the delights of a stable normal voltage.

Disadvantages: The connection block was too flimsy. When stretched (who knows - you need to make a good effort) burst under the grounding conductor. Finding a similar one turned out to be not so easy - only in the ASC Resant. Judging by the dialogue with the service center, it is in demand. Fortunately, it costs 300 rubles. I think this is a bottleneck that needs some work. Every electronics store has pads used in manufacturing for years - why reinvent the wheel. There is one more drawback - in order to hang it on the wall, you had to make a shelf. It would be nice for the manufacturer to simply complete it with a set of corner brackets, leaving the choice to the buyer - to hang it or put it, and not to invent a new shape and sell it under the new LUX position.

Comment: You can take it.

Advantages: Just hang up and plug. Fully copes with its task.

Disadvantages: Clicks loudly if the input is in a room or behind one partition can be stressful.

Comment: It so happened that at the recently purchased dacha there was already the same stabilizer, well, I also put mine one sequentially, not to waste the same good))) The photo shows everything without comment. If the voltage is below 160-150V, then it does not pull up to 220V, only 210V maximum. If your voltage does not fall below 170-180V, then take it boldly! For two years a refrigerator, LCD TVs, a laptop, a washing machine, various power tools have been working without interruptions and breakdowns. There is a load indicator on the upper stub (a useful thing), so judging by it, it was not possible to load it by more than 50-60%, and this with the heaters, water heaters, kettle, pumping station, etc. on.Small voltage surges during the switching of the stabilizer are noticeable only on light bulbs, this is not reflected in more complex equipment and electronics. PS .. The output indicator in any case shows 220V, even if in fact the output is 199V, as seen in the photo. Shows correctly if the voltage is below 130V and it is going to turn off))) As a result, I RECOMMEND this stub for purchase! It works out its cost 100%! I can't imagine existence in the country and in the countryside without this miracle of technology!

Advantages: Acceptable price. Holds tension well, quickly stabilizes during sudden surges. Convenient wall mounting. Beautiful appearance with built-in digital display.

Disadvantages: I haven't found it yet.

Comment: I live in a private house, I was tortured by power surges in the network, I often had to change bulbs, I was worried about expensive electrical appliances, especially about a gas boiler. The stabilizer solved this problem completely. Not a single light bulb burned out again. Working on the input from 140 to 260 V, it gives 220 at the output, with a deviation of no more than 8 percent.

Advantages: Works well, no comments

Comment: Like all relay loud clicks, but without this it is impossible in these models, the voltage pulls out according to the passport parameters, it was delivered and the store was quickly, everything is fine

Advantages: Stabilizes voltage well

Disadvantages: When switching, the relay emits characteristic clicks, quite loud. Design.

Comment: Despite the rather weak design and loud clicks when switching relays, set 5! We bought it for a country house, we keep it in the garage, so the volume of the clicks is generally indifferent. Household appliances are connected to the stabilizer (I want to note that we have 2 refrigerators of about 300 liters. Each + freezer for 240 liters; everything works simultaneously + TVs, micro wave, etc.). If one of the neighbors decides to cook by welding, then the tension sags well. The stabilizer is irreplaceable for us! Works properly. This winter there was a pretty frost for several days, the garage is not heated, they thought it would grunt. But he is not! Works for himself and works. Very satisfied.